Question about mistking misting system

[Bay687]

how do i stop the hose from vibrating.. like it vibrates too much when the water comes out, i dont know if it takes too much power or what, but the hose keeps slippin off and water keeps leakin everywhere.. any ideas to stop this?

 

[Chameleonboy]

Make sure you push the hose in all the way. I had that problem to but noticed the hose can go in a bit more.

-Clemonde

 

[Jamal319]

Hmm I know what you mean, when my mister comes on the tubing vibrates like hell. Today I tucked a piece under the bottom of the cage so its kind of straight and can't move as much cause it has something holding it down just a tad. But not sure why water is leaking all over the place for you? The tubing should be secured and tightly fit in the pump that usually is very well fit in, how does water leak?

Maybe someone else can chim in also.

 

[Bay687]

ive been trying multiple things, i have secured the line to my wall, but it vibrates like hell and the thing leaks, the hose after awhile just slips off, and i push it in as hard as possible, and the hose slips off and the system keeps going so i have water on my floor

 

[Chameleonboy]

Cut the tip of the hose again and insert it back in. See if that helps. Make sure you are useing the cutter that came with the mistking it makes perfect cuts as is needed for the mistking. You may want to send marty an e-mail if all else fails.

-Clemonde

 

[Bay687]

im thinkin it might be vibrating cuz the water travels up also.. thats a possibility

 

[jadeaudio]

You can easily figure out why it is vibrating. Simply by holding the line that is vibrating. If you hold it away from everything it won't vibrate. It vibrates because you have it touching something else. If you have the value nozzle, cut the line with a fresh end. Push with your fingers to even out the end of the line and when you cut it you may have crushed it a little. Make sure it is evenly cut. Push it into the nozzle and pull the white thing that holds the hose out with your fingers while pushing your line in as far as it will go. Put the lock on. That should do it. Also make sure you have enough line. Don't try to stretch it too much as that is probably why it is vibrating and eventually pulling off of the nozzle fitting.

 

[Gluuvan]

Also if securing the line does not work, Try to prime the pump again. Break the easiest joint and run the hose into a glass, turn the pump on. Air bubbles will most likely come out at first and then water spurts and then a steady stream let it cycle for a minute or 2, turn it off re connect the hose and try it again. This should help, if you have any other issues you can PM me, seems i have trail and error'd quiet a bit with the mist king.

 

[Marty]

If the tubing is popping out, you may have a bad collet. If you have any extra fittings, you could try pulling a collet out of another one. If you don't, then just PM me with original order number or the address and I'll send you replacement fittings and collets. You shouldn't have leaks and it shouldn't be popping out.

Marty

 

[Bradkc]

Yeah I've had the same problem, I've replaced several collets after leaky fittings.

 

[Chameleonboy]

If the tubing is popping out, you may have a bad collet. If you have any extra fittings, you could try pulling a collet out of another one. If you don't, then just PM me with original order number or the address and I'll send you replacement fittings and collets. You shouldn't have leaks and it shouldn't be popping out.

Marty

There you go the master has spoken.

-Clemonde