KeopiCat
Avid Member
Hello everyone,
I hope you and your chams are all well!
Recently I've come to the conclusion that I am in dire need of a functioning drainage system. Clean up is just messy, and I'm worried about puddles on the bottom of the cage. So, I need advice. How would you recommend I set up a drainage system? I've read through the forum about everyone's ideas and I'm still stuck because it seems no one is in a similar situation to me. I have a 24x24x48 cage and it's resting on a 29x29x~32 table. The top of the table is about 1" thick and is made of wood, so I could make modifications there, but the legs are metal. Eventually I'm hoping to purchase a Mist King, so I want something that can handle a good amount of water.
My original idea from the forum was to cut out a square in the table, add pic pipes for support, and lay a screen on top to prevent escapes. Then the water would be funneled into a bucket below. I have a problem though: how do I attach the pipes? I only have an inch to work with and I wanted them to be flush with the table. Suggestions? Should I try to figure out a way, or should I scrap that plan?
Thanks in advance,
- Keopi and Mondo
I hope you and your chams are all well!
Recently I've come to the conclusion that I am in dire need of a functioning drainage system. Clean up is just messy, and I'm worried about puddles on the bottom of the cage. So, I need advice. How would you recommend I set up a drainage system? I've read through the forum about everyone's ideas and I'm still stuck because it seems no one is in a similar situation to me. I have a 24x24x48 cage and it's resting on a 29x29x~32 table. The top of the table is about 1" thick and is made of wood, so I could make modifications there, but the legs are metal. Eventually I'm hoping to purchase a Mist King, so I want something that can handle a good amount of water.
My original idea from the forum was to cut out a square in the table, add pic pipes for support, and lay a screen on top to prevent escapes. Then the water would be funneled into a bucket below. I have a problem though: how do I attach the pipes? I only have an inch to work with and I wanted them to be flush with the table. Suggestions? Should I try to figure out a way, or should I scrap that plan?
Thanks in advance,
- Keopi and Mondo