Mist King Problems

[zachmcgaughey]

Hello I am setting up a mist king and the pump is working but it is not creating the suction to get the water out of the bucket.
Please any suggestions cant hurt.
Thanks

 

[MelissaB]

Sometimes you have to prime the pump, by running it without having it attached to the mist head, first. You remove the hose from the mist head (remember to push down on the collar while you pull the line out), and run the pump, with the end of the hose over a bucket, until water comes out of the hose. Usually takes 30 seconds or less. Turn it off, hook the mist head back up, and turn it on again to make sure it worked.


ETA:
Also, make sure you have your intake hose in the right spot. One side is for water going into the pump, and the other side goes to the mist head

 

[Jordyt]

Make sure that the hoses are tightly fitting into the intakes. If they are not you won't get the suction.

Also make sure that the hose isn't too kinked. You can loop them around, but if they are bent, it won't work.