Stands for a cage?

[ColeCham333]

Does anyone have any good ideas on what I can put a 24x24x48 cage on for a stand? Cheaper is better

 

[JacksJill]

Try a thrift store for a used end table or cabinet.

 

[Furciferocious]

I got some 1.5" square stock (wood) from the hardware store, cut 4 legs and 4 rails, and screwed them together with pocket hole screws. Think of a table with no top, where the drip tray becomes the top. Just don't set anything heavy on the floor of the cage.

 

[WAMBO]

I used this, but wired all the pieces together to ensure that it did not fall apart. I used two, but you could use one and turn face down. Just place the connectors on their flat side to set the cage upon.

http://www.kmart.com/essential-home-4-cube-wire-storage-unit-set/p-011W006290669001P

 

[Kristen Wilkins]

I used this, but wired all the pieces together to ensure that it did not fall apart. I used two, but you could use one and turn face down. Just place the connectors on their flat side to set the cage upon.

http://www.kmart.com/essential-home-4-cube-wire-storage-unit-set/p-011W006290669001P

Funny I was just going to suggest your Design

 

[absolutbill]

I use the plastic utility sinks at Home Depot. They are about $50, but have a drain hole in the bottom. So, you put your cage on the edges of the sink and zip tie them down so they are secure. Under the drain hole just put a bucket or a carboy to collect any draining water and presto, you have both a stand and perfect drainage for your cage!