Has anyone modded a repribreeze?

[Ta2Smitty]

Hello I’m curious if anyone here has ever made a repribreeze smaller, width wise? I’m trying to squeeze 4 into my rack but I need to take around half an inch off one of them. I’ve had their cages in the past but don’t recall how they’re made.

 

[Fraservet]

The end/corner pieces come out of the long pieces so they should be easy to shorten. The tricky bit will be the mesh I think.

 

[Beman]

^^^ This... So you would have to cut the top and bottom panels width down. Take off the end cap and cut down the straight piece to size. Then pop on the end pieces. You might be able to pull the screen up and out of the end piece and out a bit of the width to cut back then rescreen into the side that you put back on... Then put the enclosure back together.

 

[Ta2Smitty]

Ok I couldn’t remember if the corners were removeable. I can reroll the screen back in or reroll it with new screen

 

[Ta2Smitty]

Thanks guy’s as long as the corners are to removable I’ll be good to go

 

[Klyde O'Scope]

As long as you're going to those lengths (no pun intended), have you considered building one or more from scratch? Some (self included) sometimes find that easier than messing around with what someone else did previously. You may be replacing some framing pieces, screening, and spline anyway. Just a thought.