Recent content by Ruthless

Assuming you have a adult Cham then yes but also without a solar meter to be safe have a minimum of 6 inches from the top of your chams dorsal spines and T5 HO zoomed 5% or Arcadia 6%

Rainbow mealworms I have always had great customer service from them. As for supplies it all depends on what you will need to get but there are few to start with reptile basics, joshes frogs, LLLreptiles etc.

Yes I have watched that podcast a couple times. FYI Vivtech is selling them already and is SOLD OUT https://www.vivtechproducts.com/index.php/shop/SurSun-Jungle-Cover-UV-LED-p363266135 I seen them at the Anaheim super show. And after you watch it go onto watch this as well

? tried to delete

Ok yes Zoomed is a big name company but then again so is Arcadia. Think about who and what company did everyone look to for reptile husbandry? Yes it was most likely Zoomed and yes they are a big name in this hobby but from what I have seen and read they do care for the well being of there...

Sorry but are you comparing tech that can be done on a PC to UVB tech that can affect the livelihood of your reptile?

What I don’t get is why dose John Courteney-Smith would go to say that uvb led is far from being ready and yet there is 2 companies who now have them available ZooMed and Vivtech. 🤔

That’s a gorgeous looking Cham!

Do you have a drainage system? What are they built out of?

I have used the smaller version and they work perfectly fine. Not sure you would need this type cause it wouldn’t make sense to put inside the cage itself. Unless your keeping your chams outdoors.

Exactly what I was thinking. Perhaps it’s some new sales pitch like when you go shopping for a car. 🤷🏻‍♂️ It’s too bad @Strembicki213 was taken advantage of 🤦‍♂️

Dang that’s a bummer you pay too dollar for the cage and have to deal with these types of issues. Got me concerned now I have 12 of DS new nursery cages still in the box 📦 from a few weeks ago. Hope I don’t run into this if so I will be touching base with Bill.

For any of you that didn’t get to make to the Anaheim Reptile Super Show. And is looking to save some money over at Josh’s frogs! Here is a 15% OFF COUPON CODE REPSS2021 hope someone can benefit from it.

I have done this too made a pilot hole to make it much easier and to avoid possibly slipping the screwdriver 🪛 Into the screen mesh.

That doesn’t look like a egg ready to hatch. If it was it probably isn’t now the egg looks too dark looks to have gone bad. Or the neonate wasn’t healthy enough to hatch out.