Recent content by Marisol

The opening would be about 25" from the top, I could add 1in addition on the door. So it would end up being 1 3/4". I kind of made my own drainage. Its a little hard to explain so I'll try my best. Because of space in my current room I wanted to make a basin so that when water drips it can go...

I watched a lot of video on youtube on different ways people have build enclosure and terrariums. I took different techniques and ideas from each one but I say this video i found on youtube was helpful in the supplies and application. I am going to say this video is not made specifically for a...

thanks for the link! I've been looking it over and been finding a lot of helpful information for when i get my upgrade enclosure started.

Thanks for the video :) helped understand the chimney effect. After looking over my enclosure to see if I can alter the maintenance door. I can maybe expose an opening of 6"x3/4". I'm not sure if that would be enough ventilation for the maintenance door. Any feed back would be nice

Thanks for the tip! I'll put that in the my notes for my upgrade 👍🏻

Yea I realize that the numbers will vary once I get the mistking in. For now I've just been playing around to see where my current numbers are. End of February I'll be getting my mistking and 2nd govee. I'll probably rearrange some items if need be for the mistking. Want to make sure none of my...

I should be getting the mistking by the end of February. I'm hand misting for now. I mist 5min before the uvb and jungle dawn turn on. They go on at 8am and heat lamb goes on at 8:30am. So I mist for 2min wait a min then mist for another 2min. I do the same thing 5min before the lights go off at...

I do have a govee plus 2 digital thermometers. I'm planning on getting a 2nd govee soon to have a better reading of middle temp. I know its hard to see in the picture but its there. I'm already getting started on my plans for the upgrade enclosure. I used the first enclosure as a learning...

I used foam board 1/4", bought it at Walmart. I used zip ties to attach to the frame.

Thanks for the tips! Unfortunately though when I built the enclosure I did cover the maintenance door because of the drainage basin. Do you think I can still put the shrink wrap on the door and just not cover 3in from the bottom to allow air flow? I do have some small branches in the back but...

I wrapped it around my umbrella plant and used plant wire to secure to branches. So far its been doing well with water exposure.

I don't yet have him but I'm getting him from iPardalis. He will be 3 months when I receive him, once he hatches.

I'm attaching some pictures and I'd appreciate some constructive criticism and any improvement or changes I can do. For the outer shell I used a ReptiMed 18x18x36. I covered the three side panels with 1/4in cardboard foam and covered it up with some GreatStuff Foam. I did add two wall pots so I...