whats the best way to hold branches up in a screen cage

lilj0e

New Member
i was just wondering if anyone had any suggestions on whats the best way to anchor all the branches in a screen cage any suggestions would help
 
I used some wire that I had from when I used to make jewelry, and attached the larger branches to the sides, where ever they would make contact. Then I used zip ties to attach the smaller branches to those.
 
u may have to drill small holes to allow the zip tie inside and out..that could be a problem if u change thier setup later on
 
I used twisty ties and also would run them from support post to support post squeezing them around each support post as I went. I have one of the screen cages that zips around the framework, and it was tight but secure.
 
Back
Top Bottom